For an HVAC system, how do I punch a hole in the sheet metal and install a take off?
kingoftown77 asked:
I want to tap into my HVAC system to run some heating registers into a new room. What is the best (and cheap- this rules out that Greentree tool) way to punch a hole into the sheet metal of the square metal soffit and then install a take off?
air conditioner maintenance Chester
I want to tap into my HVAC system to run some heating registers into a new room. What is the best (and cheap- this rules out that Greentree tool) way to punch a hole into the sheet metal of the square metal soffit and then install a take off?
air conditioner maintenance Chester
heat pump maintenance Chesterfield
Don’t rule out Greenlee it’s most efficient…just rent it!!!
Gas Furnace Maintenance Midlothian
u can mark the size of the take off and use a chisel on a hard angle to make a whole or gash large enough to use metal sheers to cut out the hole u need……..also u can get a cheap attachment that will attach to ur drill……..
lic. gen. contractor
Gas Furnace Repair Glenn Allen
if you don’t have a drill use hammer and nail